Why won't my washer spin?

bcblage Posts: 1, Reputation: 1

New Member

Dec 20, 2011, 05:35 AM

Why won't my washer spin?

Kenmore 300 series washers that has issues. Changed lid switch but wasn't the problem. Fills, agigates and then works for a few loads again then it quits. Tub seemed loose and if moved just right seems to trigger the motor to work. Is there something under the tub that could affect it. It is not the timer since it does work.

Check out some similar questions!

My whirlpool washer works fine, just does not spin on the final spin [ 0 Answers ]

By the final spin, it will not spin, though it makes noise like it is, but the clothes are still very wet. Sometimes it does spin though. Seems like it's moody.

Direct drive washer won't spin-rotate tube 4 inches and it will spin [ 1 Answers ]

I have a direct drive washer. Have checked the motor coupler. Replaced the clutch. When it gets to the spin cycle it won't spin. If you open the lid and rotate the tub counterclockwise about 4 inches then close the lid it will spin. What could be wrong?

Whirlpool washer, agitator works, but during the spin cycle it doesn't spin [ 1 Answers ]

I have a whirlpool washer, I replaced the outer tub and the drive block, but it now doesn't spin. It drains the water, I can hear the motor come on, and feel the vibration . The switch is fine. I looked at the couple, but did not take it apart. The clutch looked fine, sanded the pads and case....

Kenmore Elite Washer does not spin in slow spin cycle until lid is opened and closed [ 0 Answers ]

I have a Kenmore Elite Top Loading Washer, Model 110.24952300. When the washer goes to the spin cycle, it does not spin in the first spin cycle. It does this in the slow spin cycle that precedes the main spin cycle. When it cycles to the regular spin cycle, it does spin properly. I found that...

View more questions Search

Check out some similar questions!

Add your answer here.