[indy57]

We replaced the cartridge in our bathroom faucet this weekend because it was leaking. After putting the new cartridge in we no longer have the same pressure as before replacing. It is really bad when you turn it to the hot water. Any suggestions?

[massplumber2008]

Hi Indy...

Yup, I have an idea, but you probably won't like it... ;)

Here, I would recommend disassembling the work you did and check to see what may have come loose. While the cartridge is out put a towel over the faucet and pulse the hot and cold water supplies on to clear the lines of any gunk/sediment. Double check all parts of the cartridge and reinstall all.

Now, as a final step, remove the aerator at the end of the faucet spout and clean it... run water without the aerator in place to clear the faucet.

With any luck, you should now be all set. If not, let me know, OK?

Mark