Ask Experts Questions for FREE Help !
Ask
    jr1966's Avatar
    jr1966 Posts: 2, Reputation: 1
    New Member
     
    #1

    Dec 18, 2011, 09:16 AM
    Furnace fan cycles off and on every 90 secs.
    1984 coleman 7680c856 standing pilot light. Burner runs reaching operating temp blower fan kicks on for 90 secs then cycles off for 2 1/2 minutes. Then back on for 90 secs while burner runs the entire time.replaced with new gas valve,fan switch,limit switch.flame on burner appears blue. Acts like not building enough heat to keep fan on. This is in a mobile home.

Check out some similar questions!

My blower fan/furnace motor on my natural gas/air conditioning system short cycles? [ 1 Answers ]

This summer I had my air conditioning unit replaced after the previous one unknowingly froze up and as a result blew up. The new unit was working well after it was installed in conjunction with the natural gas furnace without issue - albeit the blower on the furnace unit distributes the cold air...

Bryant furnace fan cycles on 1 or 2 times for 2 or 3 sec. After heat cycle has ended [ 8 Answers ]

I have a Bryant furnace Mod. #394GAD024050 and after the temp has reached the set point and the furnace has cycled off the fan will come back on a couple of times for approx. 2 or 3 seconds. In the older furnaces with a machanical fan/limit switch some times the temp would creep up and cause the...

No cooling, makes quirky noise from near outside fan for about a sec every 30 secs [ 1 Answers ]

I have a LENNOX G40UH (X) Series home heating/cooling unit. The outdoor fan and the inside unit fan are working fine, effect of ONLY fan and no a/c cooling. Also can hear a quirky noise near the outdoor fan for a second about every 30 seconds. Any idea what could be wrong with the unit? Please let...

Furnace cycles on and off [ 3 Answers ]

I have a Tempstar 5000 gas forced air furnace installed around 1993. The model number is NCC5075BFA1 and the serial is NCC5075BFA1. My furnace cycles on and off. The air is plenty warm when it does blow. The sequence is the furnace ignites, the blower comes on for maybe a minute or two, the...

Furnace cycles on and off [ 10 Answers ]

I have a Heil PGAA24C1K1 natural gas furnace with a programmable thermostat, digital type. The unit cycles on and off frequently when heating, I've done a lot of searching but my problem is different that most others I read. First, this only happens when it's cold outside, like 25 degrees or...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.