Ask Experts Questions for FREE Help !
Ask
    PastorKen's Avatar
    PastorKen Posts: 2, Reputation: 1
    New Member
     
    #1

    Dec 15, 2011, 10:26 PM
    Heil model PGAA60GIK4 burner assembly
    Our church has a Heil PGAA60GIK4 unit I would like to get some parts information for. Some folks complained of smelling gas real bad last week and we had a service man come look at the unit. It's a 1997 model and he said it needed replaced. I don't believe that. The air conditioner is wonderful but he said some of the seven burners were (collapsed?). I had someone ask him if we could have the burners replaced and he said it would cost about as much to replace as for a whole new HVAC unit. That's when I decided he just wanted to make a sale. Please advise what our options are as we are on a tight budget and want to replace what's needed to get the heat back on. We'll replace the whole heating (burner) assembly if we knew the parts to order (part numbers etc.). Is there a repair manual available for this unit? I'd like to obtain one even though we'll have a certified service man do the work.
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
     
    #2

    Dec 16, 2011, 09:35 PM
    Ask the company for a quote for the burner replacement. After you get the quote get a 2nd from a local dealer. Burners are cheap compared to a new system.
    PastorKen's Avatar
    PastorKen Posts: 2, Reputation: 1
    New Member
     
    #3

    Dec 17, 2011, 10:06 AM

    Thanks T-Top!
    This is a series of seven burners on what looks like a metal drawer with a disconnect in the gas line. When you refer to a burner replacement, does this come as an assembly with all seven elements or is each element a separate piece. The service man said that three were collapsed (probably rusted through from the propane gas)so I'd like to replace the whole assembly.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Blower assembly vibration, Heil gas furnace [ 1 Answers ]

Heil gas furnace model GDE075F16A3. The furnace just quit working. The fault was a broken lead on the secondary of the 115V to 24V transformer. With the furnace operating again, I noticed that the blower motor/fan assembly was vibrating. The wife and I removed the assembly for inspection. During...

Flame color on Burner Assembly? [ 1 Answers ]

What's the proper color of flame supposed to be comiing out of the burner assembly. My color is yellowish orange.

1992 ruud model 90, burner assembly? Screen is burnt out. [ 12 Answers ]

Are there any burner upgrades for this furnace? Ruud mod 90 ser#bu5707 m46921326. The screen is burnt off it and the tech says the part has been discontinued. Thanks for any help. Lou

Heil furnace burner igintes then goes out [ 3 Answers ]

I have a Heil furnace model number NUGK075AG02 (75,000 btu's) and the burner ignites for about 15 seconds then goes out and the fan continues to run. What might be the problem? Deka

Heil furnace short cycling of burner [ 1 Answers ]

My 1983 heil model NUGK075DG01, natural gas, forced air furnace is running but only heats the house to 67 degrees no matter how high I set the temp, the fan continuously runs (in auto on thermostat) and the burner will cycle for 3-4 min. then shut-off for 10 min.. I have powered down and back-on,...


View more questions Search