Ask Experts Questions for FREE Help !
Ask
    newcomer2011's Avatar
    newcomer2011 Posts: 10, Reputation: 1
    New Member
    		  
    #1

    Dec 12, 2011, 02:40 PM
    Pilot Light doesn't not come on.
    This is an older Interherm Gas Furnace. Inspector could not turn on the Furnace to check. Pilot light doesn't come on. Blower is blowing but air is not warm. Thermostat clicks but no effect. What could it be?
    Irene.
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #2

    Dec 12, 2011, 05:41 PM
    Could be many things. I suggest calling in an hvac tech to check the system. Most likely it will be an easy fix, but will require the knowledge to figure it out.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Propane Furnace won't start no pilot light red light flashes 3 times [ 6 Answers ]

My propane furnace G6RC has no visible flame and the red light either stays on or flashes 3 times in a row and then the furnace shuts off and tries to restart

Gas wall heater pilot light goes out when I turn the valve from 'pilot' to 'on'. [ 1 Answers ]

Why does my gas wall heater pilot light go out when I turn the valve from 'pilot' to 'on'? The pilot lights and stays lit until I try to turn the valve. It's got a brand new thermocouple.

I cannot find the button to push to light pilot light on older Maytag washer. [ 6 Answers ]

I am trying to light the pilot light on my older Maytag dryer. I cannot find any button to push while lighting the light area. All I see are screws, and electrical wire connections. The dryer does not heat and I assume that it is old enough to have a pilot that needs lighting. Thanks

Does putting gas hot water heater dial on PILOT put pilot light out? [ 5 Answers ]

My gas hot water heater dial has OFF to the left, PILOT in the middle and ON to the right. If we are going away and want to not have the water heated can we just turn the dial to PILOT and the flame will stay lit but just won't heat the water or does the flame go out completely and then PILOT would...

Pilot light stays on but pilot switch keeps resetting [ 5 Answers ]

I have a baso L62AA-5 pilot switch and it used to keep resetting. I would hold the switch down for a good minute and the gas lights, but after a half an hour or so it would go back to its reset position. The standing pilot light was always on and never a problem. After a few days of manually...

View more questions Search