Ask Experts Questions for FREE Help !
Ask
    kriss9671's Avatar
    kriss9671 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 12, 2011, 11:13 AM
    Hunter thermostat 44155c I have it set for a certain temp the furnace keeps running
    I woke up in the middle of the night and it was 82 what is wrong?
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Dec 12, 2011, 07:36 PM
    Works like many hunter tstats do,, and many more don`t work that well

    Hunter tstats are junk, if not when you install it,down a very short road it will turn into junk
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

My gas furnace keeps running well after it passes the set temp. [ 5 Answers ]

I set the desired temp on the termostat ( 70 F ) and the furnace keeps going until we get to 90F. It blows hot no matter what... It eventually kicks off but sometimes it takes hours...

Furnace constantly on, thermostat not controlling it, can't set temp. [ 0 Answers ]

My furnace is constantly on and blowing hot air, W-R thermostat up/down buttons not changing temp setting, nor is display lighting up. Both the temp set point and current temp read 72 degrees. Disconnected white wire, furnace blows cool air but is still constantly on. Moved Heat/AC button to off,...

Ruud Gas Furnace not running up to set temp. [ 0 Answers ]

I have a Ruud gas furnace that is 3 years old. The heater ignites and runs for 1 -3 minutes with warm air blowing out, then shuts off. It repeats this cycle until it goes into lock-out. The heater never runs long enough to get up thermostat temp setting. Any ideas?

Hunter thermostat 44155c [ 1 Answers ]

I have the following colored wires coming out of the wall Green Red Orange Yellow White Black Blue The thermostat has the following connections:

Furnace not kicking on when temp drops below thermostat set temp [ 1 Answers ]

I've got a Beckett oil heat water on demand furnace that heats through baseboards. Since this past weekend the furnace hasn't been kicking on when the temperature drops below my set temp of 68 degrees. I have to go down to the furnace and simply touch the top of the reset box for it to kick on. ...

View more questions Search