Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
I have an american standard central gas heat when it call for heat I get 4 flashes in
[ 0 Answers ]
Unit blower comes on but no heat the light on control board flashes 4 times pause then 4 times again when system is calling for gas these flashes indicate that a can anyone help? Icannot find reset buttons on my unit.
Radiant heat circulating pump runs when heat is not on
[ 0 Answers ]
My radiant heat circulating pump runs without a call for heat. I did drop a thermostat when moving it, and the wires got disconnected. I began to re-attach them, without shutting the power off. I know, a mistake. I may have touched two live wires. Now the pump runs constantly without a call...
My heat pump runs good on a/c but when switched to heat compressor shuts off.
[ 0 Answers ]
Heat pump works good on a/c but when I switch to heat it starts OK (big copper line gets very hot) but after 2 minutes the compressor shuts off (condenser fan stays on) After about 8 minutes the compressor starts again then shuts off after a couple of minutes, the heat pump is a trane 5 tone2001....
Hot water heat - boiler runs for 15 minutes then cycles on and off every 15 seconds
[ 0 Answers ]
Sounds like it is lighting the boiler over and over again. I thought it might be a dirty flame sensor so I used some light sandpaper on the flame sensor but did not reolve the problem. It is a Slant/Fin Victory II Boiler Model VHS-120 EP. Thanks for your help.
Pump Runs and Runs Even When No Heat Is Needed
[ 1 Answers ]
I have a 4 zone hydronic heating system. It is a 15 year old Hydrotherm HI-B series boiler with a new circulator pump. It has been noticed that when none of the zones call for heat and the boiler is back up to temperature the pump continues to run, a waste of power since al the zone valves are... View more questions Search
|