Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Ceiling light using existing wall switch that currently controls a wall outlet plug?
[ 2 Answers ]
I have a bedroom wall outlet plug that is currently switched on/off by an existing wall swtich. I want to set up that switch to turn a new ceiling light on/off and leave the wall plug controlled also by the wall switch. Is this possible and safe to have the existing wall switch control both the...
Installing a heat duct in existing basement wall
[ 3 Answers ]
I need tips to install a 6x10 heat duct in a wall. I have installed a wood burner and want to vent one of the heat runs into a large family room. The family room side is finished, the back of the wall is in my mechanical room and unfinished.
Installing wall remote for ceiling fan into wall switch
[ 3 Answers ]
I've had no luck with getting the wall remote on my Hampton Bay ceiling fan to work. I was able to get the fan to work with the wall switch, but once I change out the switch with the wall remote it doesn't work. The l.e.d. on the wall remote is not even lighting. There are 6 switches on the...
Re-route duct work to an exterior wall
[ 6 Answers ]
Hi. We are remodeling our kitchen and while taking down a pantry closet we found an air condition duct in the interior wall. The duct goes from the basement up to the second floor. Our only option on re-routing is to the wall between the kitchen & the garage or the exterior back wall. Either is...
Drain placement on outside wall
[ 2 Answers ]
I'm putting a kitchen sink next to an outside wall. The wall is 2x4 framing, and sits on a 2x10 rim joist. My question is, do I cut the hole for the drain through the wall cavity, or can I go through the floor, since it will all be enclosed anyway? My concern is that the wall is too narrow... View more questions Search
|