Ask Experts Questions for FREE Help !
Ask
    Kellygro's Avatar
    Kellygro Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 4, 2011, 04:45 PM
    How do I test a bryant 90i inducer fan motor?
    I am getting 120 volts on a call for heat on the black and neutral coming in. Can I just test the motor by itself. Or does the current have to go through the inducer control board first. Can a person buy the inducer control board separately? Thanks
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #2

    Dec 4, 2011, 07:25 PM
    If you have the evolution control. Press and hold the advance button for 10 sec. Go to check out system. If it runs its good. If the control board is bad it will give you a message of control fault and not communicating.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant Furnace Inducer Motor Fan Squealing [ 3 Answers ]

I have a byrant furnace model 395b - the inducer motor fan squeals and I was wondering if it should be repalced or can I oil it and how? The furnace company wants $100 to look at it and I was wondering if I could do it myself!

Bryant furnace inducer motor blower keeps failing [ 34 Answers ]

I have a Bryant Plus 90 high efficiency furnace, Model 398A, about 14 years old. I am now on my third inducer motor assembly. The plastic blowers on the first two disintergrated. Does anyone have any idea as to why and what can be done to prevent another failure? Besides the inconvenience of no...

Inducer motor rattles on bryant [ 1 Answers ]

I have a Bryant BVR24 and I got a Error Code 31. The inducer motor is rattling and turning very slowly when the thermostat is turned on. This is causing the heater not to turn on. What could be causing this. It is something that just started and we have had the heater for 12 years.

Draft Inducer motor (Bryant 373LAV hoz) issues [ 3 Answers ]

I trigger the furnace using the TEST lead to the common lead. The inducer motor starts (somewhat slowly), the ignitor glows, missing gas flow rom the GSV and then the blower tuns on and then shuts off. No fault code. I replaced the gas valve, no change. I checked the pressure switch for the draft...

Bryant Plus 90i Inducer Housing Leaking - Water on the floor [ 0 Answers ]

A service rep came out and said it would cost 400.00 to replace inducer motor/housing. I asked him to try and repair it so he removed it, opened it and removed the old silicon sealant and put new sealant in it's place. The leak stopped for one month, but now there is water on the floor again. Not...

View more questions Search