Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Water Heater Replacement Created Water Pressure Loss
[ 8 Answers ]
I recently replaced my hot water heater, basically same capacity, etc. as the previous heater. I am noticing a drop in water pressure in the entire house, guess would be 20-25%. The only change is I used a dielectric union between the new heater and copper pipe. I have to assume the water heater...
Low hot water pressure through the whole house even ater replacing water heater
[ 2 Answers ]
I'm still experiencing low hot water pressure even after replacing the water heater. When you first turn on the faucets the pressure will be fine but within a few seconds it drops again.
Low water pressure in shower after replacing water heater
[ 4 Answers ]
We have almost no pressure with the hot water in the shower after replacing the water heater. Cold water is OK, we have flushed out the pipes (refilled the water heater) and still not any better. What next? We have look on line for answers but to no avail.
Electric Hot Water Heater still doesn't heat after replacing thermostats
[ 2 Answers ]
Electric Hot water heater was working. Turned well pump off and went on vacation for three weeks. Got back and found I had no hot water. Call Whirlpool, their heater, they told me to replace both upper and lower thermostats after I gave them some voltage and resistive measurements. Replaced...
Electric Hot Water Heater - replacing anode rod
[ 3 Answers ]
What is the procedure for replacing the anode that is screwed into the top of an electric hot water tank? In theory it's supposed to be easily replaced, but in real life getting any fitting unscrewed after many years can be a risky. Any tricks or just brute strength? I haven't change it. I... View more questions Search
|