 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Replacement baseboard heater stopped working
New baseboard heater run by thermostat connected to 3 heaters, that were original in 1971. All three heaters had stopped working at different times. Replaced the 1 that had stopped last. At the time I got 120 volts from wire. After 3 days, it stopped working. I now get 17 volts from neutral (white) wire only. Checked other two, and one gets 7 volts, and the other 43, again both just from the neutral wires, with nothing from the power (black). What am I probably looking at?
|
||||
Check out some similar questions!
When tearing down a wall, I removed two, connected baseboard heaters, installed a junction box and ran the wire under the new floor (I would say the junction box is now unaccessible). Power to both the thermostat and the heater wiring was tested good and I tried both a new thermostat and a new...
Do baseboard heater loose efficiency if they are old? Do I need to replace them if they are 30+ years old but still work?
I installed a Cadet 240v elect with a King double pole thermostat from a double pole breaker. Followed the instructions for both the heater and the thermostat. When the thermostat is turned up, there are two 120v lines to the heater, but the heater does not heat up. When I test each line in the...
I have baseboard heating and two or three years ago I had two replaced on internal walls with forced air wall heaters. I didn't have the thermostats replaced. All of a sudden they won't work, and neither does the baseboard heater on the same thermostat as one of them. The thermostats appear to...
Hello! We had a Buderus gas water heater installed in October 2008 (for both hot water and heating). It worked fine until a few weeks ago, when it stopped working suddenly, and the sensor showed that there wasn't enough water (low water light was on); after a couple of hours (or less), it...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
