Ask Experts Questions for FREE Help !
Ask
    flirraragon's Avatar
    flirraragon Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 27, 2011, 02:27 PM
    Gas furnace troubleshooting glow coil goes on but no flame?
    Glow coil comes on but no flame does this 2 or 3 times and sometimes comes on or it will completely shut off.

Check out some similar questions!

Gas furnace - no flame [ 4 Answers ]

Hope someone out there can help, because it's going to get cold this weekend! I have a split HVAC unit with furnace in attic. Written on front of unit is Intertherm. Inside panel of unit says Nordyne, and the Ignition Control is Robert Shaw. The unit is 13 years old and the heat worked fine...

Gas furnace, fan works, but no flame [ 2 Answers ]

I have a gas furnace. House is 55 degrees. Thermostat is set at 80 degrees, switch on furnace is in on position and fan/blower works, Gas is present in hot water heater 24": away on same line and stove works in kitchen. Breakers are OK. Furnace does not light. No gas smell. Help!! ...

Furnace blower will not stop after flame goes out on gas furnace [ 1 Answers ]

Furnace blower will not stop after flame goes out on a gas furnace

Gas furnace Cycle Blows but no Flame [ 4 Answers ]

We have a Comfortmaker Furnace that is about 3 years old. It will act like it is going to turn on with the blower moter kicking on but the flame never turns on. Then the motor stops. Then about a minute later it repeats the cycle. It will do this for about 5-7 minutes several times a day. ...

Gas furnace, intermitant flame [ 1 Answers ]

I have a Day &Night gas furnace and the gas flame will stay on for a few seconds and then shut off for several seconds. The pilot stays lit and the thermostat calls for heat. The blower continues running as the flame cycles. Any idea where to start trouble shooting? Thanks for any help, Greg

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.