Ask Experts Questions for FREE Help !
Ask
    Rlackey's Avatar
    Rlackey Posts: 2, Reputation: 1
    New Member
     
    #1

    Nov 27, 2011, 06:36 AM
    can 14 gauge be used
    Just trying to find the standard codes for the # of outlets for each breaker for the typical amperage...

    15 amp 110 volt
    20 amp 110 volt

    the space is 12 x 20 ?
    tkrussell's Avatar
    tkrussell Posts: 9,659, Reputation: 725
    Uber Member
     
    #2

    Nov 27, 2011, 06:41 AM
    What will the space be used for? Some areas such as a dining room needs 20 amp circuit with #12 wire. A den can use 15 Amp with #14 wire.

    Certain rooms need GFI protection, others need Arc Fault protection.

    There is no limit of outlets on a residential general purpose circuit.

    You may use the non-residential limit as a guide line of 10 outlets on 15 amp circuit and 13 outlets on a 20 amp circuit.
    Rlackey's Avatar
    Rlackey Posts: 2, Reputation: 1
    New Member
     
    #3

    Nov 27, 2011, 07:05 AM
    It is more of a game room a refrigerator TV radio table lamp Ceiling fan and it may later on have a a/c window unit
    donf's Avatar
    donf Posts: 5,679, Reputation: 582
    Printers & Electronics Expert
     
    #4

    Nov 27, 2011, 07:08 PM
    I would use a 20 amp circuit if you intend to power the entire room off the one circuit,
    tommybwiz's Avatar
    tommybwiz Posts: 58, Reputation: 2
    Junior Member
     
    #5

    Dec 1, 2011, 11:34 AM
    You may also consider adding an extra designated circuit for the "future" a/c unit. It is easier to prewire now than to attempt to add later if needed.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Is it safe to replacing a lighter gauge wire with a heavier gauge [ 11 Answers ]

Hi all, One of my baseboard heater (240v)'s wire was broken can I replace it with a heavier gauge wire? Also can different gauge ground wires (copper wire) be connected with a wire-nut? IS THIS SAFE TO DO? OR Will this create a fire hazard?

Drove the cooling high hot gauge and back to normal gauge problems? [ 0 Answers ]

Overheating problem and smell combustion gasses with the cooling. What is problem from ?

1991 Honda Civic Tack, water gauge, fuel gauge problem? [ 2 Answers ]

My tack, fuel gauge and water temp gauge all went to zero. I could not find any fuzes that were out. Is there anything that would provide power to these three items?

Failed gass gauge and temperature gauge on 1988 Nissan Pathfinder [ 1 Answers ]

I have a 1988 Nissan Pathfinder 4x4. The gas gauge and the temperature gauge would stop working at the same time when the car warmed up. They both would come back on periodically and then off again. Currently they have not come back on in about 3 months. How do I fix this problem?


View more questions Search