 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Furnace working for short periods only after cleaning out gas chamber.
I clean out the gas chamber by blowing out with air pressure and furnace seems to work all right for a while. Then the burner kicks on and lights, but goes off. It then kicks on again and stays lite. After a few days the burners won't stay on and the red light blinks twice again. Clean it out and we start over again.
|
||||
Check out some similar questions!
G6RC 40k BTU single pipe (exhaust) 90+ Natural gas furnace in light duty service for some 10 years. The unit has a small combustion chamber inside the cabinet with a spyglass. Standard issue hot surface ignitor and a rectifier flame sensor. find documentation here:...
Who do you call to clean your gas furnace? Do you need to have it clean and who can you call to do this? Lives in a house that has a gas furnace that hasn't been clean for two years since we bought the house. Need to know if this needs to be by a professional or can we do it, if so, how do you...
Hello. My gas furnace does produce heat when it first comes on. But after a few minutes the air turns warm, then looses all its heat. Do I just need a new heating element? Thanks a Million, McClint (vitalpilot)
I have an older Sears "Fifteen" horizontal gas furnace (#867767840) located in the crawl space. Recently it has been short cycling, meaning it starts a normal cycle, runs for approximately 1 minute, stops for several minutes, then starts another 1 minute cycle. This repeats until the set...
Unit: Carrier WeatherMaker 9200 gas furnace, with an HSI ignitor Symptom 1: Thermostat is calling for heat, as evidenced by a flame icon on thermostat face, but no action in the furnace. Symptom 2: Ignites only AFTER I initiate Action 2 below. Then it seems to work for a while, until the...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
