Ask Experts Questions for FREE Help !
Ask
    superburrito's Avatar
    superburrito Posts: 1, Reputation: 1
    New Member
     
    #1

    Nov 16, 2011, 07:47 PM
    Changing the motor on an air compressor
    I recently purchased a 5hp 80 gallon compressor, but it runs on three phase power. I do not have three phase at my house. I was able to find a single phase motor of the same horsepower and specs as the three phase. The mag starter that came with the compressor was wired for three phase. How can I wire the new single phase through the three phase starter, and where does the pressure switch wire in?

Check out some similar questions!

Air conditioning compressor motor price [ 1 Answers ]

Are the motors in domestic Mitsubishi air conditioning compressors sealed units ? Does the whole unit have to be replaced or can just the motor be replaced ? What is a ballpark price for a replacement 8A 140VA compressor ?

Air compressor changing motor [ 35 Answers ]

I recently bought an air compressor with three phase power. I do not have three phase in this older property so I knew I would need to change the motor. I found a single phase 7.5 hp. Motor with the same shaft, etc. dimensions as the old three phase that I traded to a guy with the opposite problem....

Air compressor motor change [ 13 Answers ]

I recently bought an air compressor with three phase power. I do not have three phase in this older property so I knew I would need to change the motor. I found a single phase 7.5 hp. Motor with the same shaft, etc. dimensions as the old three phase that I traded to a guy with the opposite problem....

Air compressor motor [ 5 Answers ]

I have a 230 volt 15 amp 60 hz 1 ph air compressor motor I want to wire. I am little confused when I open the switch there is 1 black, 1 white and one ground. I am to assume that the white is to be hot to be 230 volts. I'm running 14/3 through out my walls with a 20 amp dual pole breaker. So in...

Air compressor ac motor flips breaker after delay [ 5 Answers ]

Hello thank you for taking the time to look/answer my question. That being said my problem is with a ac motor for a air compressor it worked fine then all of a sudden it started to throw the breaker. It will start and run fine for about 5-7 seconds then it will flip the breaker. Any advise will be...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.