Ask Experts Questions for FREE Help !
Ask
    djcurtis7's Avatar
    djcurtis7 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Nov 13, 2011, 01:42 PM
    Is it normal for a new toto 715 to stop the flush progress if you let go the handle b
    Is it normal for a new toto 715 to stop the flush progress if you let go the handle because I have to hold the handle to get a full flush
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Nov 13, 2011, 02:02 PM
    Sounds like your lift chain may be too long or the lift arm is not adjusted properly. Flapper should be almost vertical when flushed and float down with the water unless it has a timing cup.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Why Might a Person Have to Hold Down the Handle on a Toilet to Make it Flush? [ 5 Answers ]

Hi, All! The title is my basic question. Here it is, a little more elaborated. Why might a person have to hold down the handle on a toilet in order to make it flush all the way? It's a basement toilet that isn't used all that much. I replaced the flush mechanism about ten years ago. ...

Toilet Leaking out of Flush Handle [ 5 Answers ]

Our toilet fills up and leaks out of the flush handle. I turned off the water supply, and checked the screw to see that it was at the right level, checked the ball to make sure there weren't any holes and when I pull up on the ball lever it shuts the water off, but it still fills up and over flows...

Toilet handle needs be held down to flush [ 2 Answers ]

How do we fix: toilet handle needs be held down to flush:(

Toilet Flush handle broken? [ 2 Answers ]

Hello, I'm a newbie. Need help understanding if my toilet flush handle/lever is broken and how to fix it. I noticed that sometimes the plastic lever gets stuck under the flapper preventing it from closing. Jigging the handle from outside usually does the trick but it is a pain to always do this....

Handle goes down, but toilet doesn't flush [ 2 Answers ]

Hi, I press the handle on the toilet, but the toilet does not flush. The screw(?) inside the tank attached to the handle appears to be rusted. Chain is intact. What do I do? Thanks much!

View more questions Search