 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Bryant 350 mav furnace (propane) problems
"Woke up to cold house" blower was running but no heat. Checked unit and had a 13 code flash on LED. Made sure there were no obstructions in/out with airflow. Checked and cleaned flame sensor, replaced rollout switch (at advice of tech) and drained all of condensation at bottom of unit... If I reset the breaker and reset rollout switch, unit will restart and run through heating to temp at thermostat before kicking off and returning to the 33 code which later changes to the 13. I have also replaced the thermostat... any ideas It is Saturday and its cold..
|
||||
Check out some similar questions!
I hear water flowing from the "pump" outside the furnace, that has a tubing connected to a train tube by the sink nearby. I looked inside the bos ("pump"), there is some solution (like antifreezer) inside, but vary shallow. What should I do to silent this pump, or to fix this problem?
Recently had a situation where the furnace was shutting off the gas. It was found that the flame roll out safety was activating. Originally I thought I had a cracked heat exchange, but on inspection it was not. Ultimately I found that there was a bee's cone in the intake restricting the fresh...
I have a Bryant gas furnace Model Plus 90i 355MAV. When it runs in high heat mode for several minutes it makes this thumping sound that seems to be coming from the blower area, after a couple of seconds the furnace shuts down. Any Help? Unit is about 6 years old
Hi, Have a chance to buy a 5 year old propane furnace, Bryant 135K BTU, upflow, with 5 ton blower air conditioner is Bryant, furnace model is: 383kav060135. Really just want the furnace but have to buy both. Any thoughts on this furnace? I presume I wouldn't have to install the ac unit if...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
