 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Furnace with a B18099-13 control board.
I have a furnace with a B18099-13 control board. The status light says I have a gas problem or sensor. I have replaced the sensor and gas valve. It has ignited only a couple of times since I replaced them and the burner goes out then the lightstarts flashing again when the fan shuts off. Do I have a bad board?
|
||||
Check out some similar questions!
I have a Carrier 58PAV that intermittently aborts or sometimes clicks on and off at the draft blower stage. I found out I can move the control board (HK42FZ007) when the blower motor clicks off, and it clicks and comes right back on. If I hold it just right, the furnace starts and if I manage to...
I have a bryant furnace can I get this to run without the control board seeing how the board in there is bad I've asked others but get different answers can I wire the furnace without this control board in it it's a 325878-751 board.
We purchased a new controlboard for our rheem furnace but it is not exactly the same and the wiring diagram is not matching up like the old one, for instance with the old one the heat and cold wires are black and blue on the new one the diagram says balck and red. Why is it different, and is there...
Hi, I have a Carrier furnace 48GS-036090311TP with a Honeywell T8401C thermostat. I can run the fan on continuously but when I put the Heat to ON on the T-stat, the 5 Amp fuse on the control board (LH33WP003A) in the furnace blows. The sequence is like this: 1. Fan only operation is running...
Can the board be repaired or do I need to replace it
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
