Ask Experts Questions for FREE Help !
Ask
    Pasloade74's Avatar
    Pasloade74 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 21, 2010, 02:17 PM
    My furnace won't stay lit
    Sometimes my furnace will go through the cycle of trying to ignite 4 times without actually igniting. The 2 right burners will light up but will die out after a few seconds while the 2 left ones won't light at all. After it attempts to light up 4 times the whole system shuts down and a red light starts to blink.

    I just replaced the ignator a few monthes back and seems to work fine. I have a new filter as well so I don't think it could be air flow. What else could it be?
    wenze's Avatar
    wenze Posts: 2, Reputation: 1
    New Member
    		  
    #2

    Nov 9, 2011, 09:09 AM
    My furnace doesn't stay lit what should I look for
    wenze's Avatar
    wenze Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Nov 9, 2011, 09:11 AM
    My furnace doesn't stay lit what should I look for
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Furnace will not stay lit [ 3 Answers ]

I have a 3 year old concord 80 plus furnace it starts up and ignites for about 10 seconds then shuts off the blower still runs this repeats for about 2-3 more times then just never comes back on again until I restart. I believe it is the round spiral hot surface ignitor what do you think?

Furnace will not stay lit [ 1 Answers ]

I have a 17 yearold Weil McLain oil burner. I just replaced the fire box and filter. It starts when you press the reset button but goes off after a minute. How do I keep it firing?

Furnace not stay lit [ 6 Answers ]

I have a Rheem Criterion II. My furnace just recently started light and then immediately have the flame go out. It doesn't do it all the time, maybe 5-6 times then the thermostat sends a signal to the furnace. I have to turn off the thermostat so that it can cycle through until it stays lit. ...

My furnace will not stay lit [ 4 Answers ]

I have a Trane XL80 furnace. I have manually started the furnace and at the time the burners will light and continue to fire for about 5 minutes then they act like they are being blown out. The LED light at the time of start up begins to blink 4 fast blinks. The blower continues to blow cold air...

Furnace won't stay lit [ 1 Answers ]

Our Heil Furnace pilot light won't stay lit. When pilot knob is turned on, we can ignite the flame, but as soon as we release knob the pilot light goes out. We also replaced the thermo coupling and it still did not stay lit/worked. Could it be the valve/knob? Would any one have any suggestions?

View more questions Search