Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Toyota 3vze engine
[ 14 Answers ]
I blew a head gasket and need some direction on how I should proceed. I'm down to the cam cover and am not sure what to do next. I've been pulling wrenches for a long time but never did a overhead cam engine. HELP
02 toyota corolla... check engine light on... car stubbles on start or moving...
[ 1 Answers ]
Car stubble's when I first give it gas then goes but intermittently stubble's I think it's the 02 sensor I replaced one but not both I had the obdII read at auto zone said that it could be the o2 and lean on the right bank so I think it could be the injector also... I have pulled the plugs and...
1990 toyota camry, washed engine now won't start
[ 1 Answers ]
I degreased the engine on my 1990 holden apollo (toyota camry) and chucked a bucket of water on it to wash it off and now it won't start, this was 3 days ago. I was careful not to hit the air filter, battery or fuses. When I take the air filter off and pump the throttle I can see fuel squirting in...
Toyota engine trouble - 2.4L DOHC
[ 4 Answers ]
(1994 toyota previa - 2.4L DOHC) This toyota was sitting up for months after it overheated and blew the head gasket. The head was given a valve job and reinstalled. The van idles/drives GOOD when warm, but idles very rough and dies when cold. After it warms the engine light comes on. (OBD...
Need to identify toyota engine
[ 3 Answers ]
I dug out an old toyota engine from my dads garage and I'm trying to figure out what it is. The only code I could find on it is B616 48 View more questions Search
|