Ask Experts Questions for FREE Help !
Ask
    heil12's Avatar
    heil12 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 18, 2011, 05:43 PM
    My inducer motor is not creating enough suction
    I have a heil furnace I believe my inducer motor don't have enough suction to open they pressure switch to allow the furnace to run , I token they line off and have sucked on they line and they furnace would light do you believe my inductor motor could be going bad?
    JonesHVAC's Avatar
    JonesHVAC Posts: 173, Reputation: 12
    Junior Member
    		  
    #2

    Oct 18, 2011, 08:09 PM
    That is highly possible you would have to check the amp draw during operation. You could also have a restriction in the line... remove the line completely and blow it out, careful not to spit while your blowing, lol. Also may have a restriction in the exhaust pipe. Check for the restrictions first as they would be your cheapest fix. Let us know.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Inducer motor? [ 1 Answers ]

When I turn my thermostat on at first I hear a humming then it blows hot air then cold air. I was told I need an Inducer motor? Does that sound correct?

How much for an inducer motor? [ 1 Answers ]

How much should it cost to replace a goodman inducer motor that is humming?

What is the inducer motor [ 3 Answers ]

I have a bryant 395C gas furnace and the inducer motor assembly is making noise. The motor seems fine and the furnace operates normally, but there is a plastic wheel attached to the end of the motor that is rattling when the motor runs. I've looked at pictures of many inducer motor...

Inducer Motor Direction [ 2 Answers ]

I have a Carrier WeatherMaker 8000 and my inducer motor goes in the opposite direction when furnace is not running. Could this cause a mis-firing. Without consistency I get a code 14 or 34 when furnace fails to work. Completed a component test and all seems well. Help.

Problem with inducer motor which just went out. [ 3 Answers ]

Hello everyone, this is my first question on this forum. I hope that some of you can help me out with this query, as I'm literally out in the cold right now. My inducer motor just went out on our central a/c heating unit. It's a York rooftop model. I am wondering if someone could guide me as to...

View more questions Search