Ask Experts Questions for FREE Help !
Ask
    steveandjackie's Avatar
    steveandjackie Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Oct 13, 2011, 03:53 PM
    Whirlpool washer sprays/soaks clothes at end of spin cycle
    I have a Whirlpool washer model # WTW57ESVWO. When washing clothes, no matter the size of the load, at the end of the spin cycle it completely soaks the clothes. It soaks them to the extent that there is about 1-2 inches of water in the basin when it is complete. Any help would be greatly appreciated.
    parttime's Avatar
    parttime Posts: 1,440, Reputation: 113
    Ultra Member
    		  
    #2

    Oct 13, 2011, 05:17 PM
    Hi steveandjackie, could be something fouled up in the pump or line causing it to drain slow. It should drain and tub full of water under 70 seconds, time that to check pump. Good luck
    parttime's Avatar
    parttime Posts: 1,440, Reputation: 113
    Ultra Member
    		  
    #3

    Oct 13, 2011, 05:19 PM
    Oh, all whirlpools spray five second burst of water on spin cycle, that's normal.
    steveandjackie's Avatar
    steveandjackie Posts: 3, Reputation: 1
    New Member
    		  
    #4

    Oct 13, 2011, 07:28 PM
    I stopped it about 1/2 way through the spin cycle & there was no water in the basin. However, when I restarted it, it ran for about 1-2 minutes and then sprayed continuously for the duration of the spin cycle. It has never done that before.
    parttime's Avatar
    parttime Posts: 1,440, Reputation: 113
    Ultra Member
    		  
    #5

    Oct 14, 2011, 03:40 AM
    Steve, sounds like a timer issue, try cleaning the contacts and look for any signs of blistering or burning. The link below should help. Good luck

    Open Whirlpool WTW57ESVW Washer Cover - YouTube
    steveandjackie's Avatar
    steveandjackie Posts: 3, Reputation: 1
    New Member
    		  
    #6

    Oct 14, 2011, 02:33 PM
    Thanks parttime. I'll have to try that this weekend when I have time.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Whirlpool washer clothes wet at end of cylce [ 12 Answers ]

Hello, I have a whirlpool washer LSR8233EQ1. After the cycles are complete, the clothes are too wet to put into the dryer. Often there is some water at the bottom of the tub. When trying to diagnose the problem, I see that the washer spins while draining. Is this normal for my model? Could...

Whirlpool washer, agitator works, but during the spin cycle it doesn't spin [ 1 Answers ]

I have a whirlpool washer, I replaced the outer tub and the drive block, but it now doesn't spin. It drains the water, I can hear the motor come on, and feel the vibration . The switch is fine. I looked at the couple, but did not take it apart. The clutch looked fine, sanded the pads and case....

Washer spin cycle clothes still wet? [ 1 Answers ]

Just wondering why my water keeps running into washer during the spin cycle which leaves the clothes wet... sometimes it continues running even after spinning has stopped?

Whirlpool washer model LSQ9564JQ0 Sprays water on clothes at END of spin cycle. [ 0 Answers ]

Whirlpool washing machine model LSQ9564JQ0 sprays water at end of cycle. Seems to drain/spin OK, but at the very end of the cycle it sprays water (same way it does during spin cycle).

Whirlpool Washer Spin Cycle [ 1 Answers ]

Just bought a new whirlpool washer (MD#: WTW5790SQ0), the spin cycle on the washer doesn't work on any cycle EXCEPT normal wash. This was determined by: closing the lid, selecting each individual spin option on the dial and pulling the knob out (starts washer). Both spin cycles work on the Normal...

View more questions Search