Ask Experts Questions for FREE Help !
Ask
    ec.doesit's Avatar
    ec.doesit Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 7, 2011, 06:44 PM
    How do you test a gas valve in a furnace for electricity?
    My good man furnace will start the igniter will ignite but the burner do not produce flame I think my gas valve is not being activated by the circuit board therefore no gas is being release. How do I test for this I am getting a 2 flashes in the code but the pressure switch is fine. Help!
    parttime's Avatar
    parttime Posts: 1,440, Reputation: 113
    Ultra Member
    		  
    #2

    Oct 8, 2011, 03:15 AM
    Hi ec. And welcome, here's how to test you coils, How to Test a Gas Valve Solenoid Coil | eHow.com good luck and let us know how it goes.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How to test a White Rogers 2 stage gas valve? [ 19 Answers ]

Hi, I have a Magic Chef Furnace with a Robertshaw Ignition Module and White Rogers Gas valve. The problem is that the gas valve will not open to start to flame to the furnace. If you turn up thermostat, I then get spark and then a pilot light. Then nothing. I have replaced the Ignition Module and...

Carrier Natural Gas Furnace main gas valve will not open every call for heat [ 1 Answers ]

We have a Carrier Weather Maker 8000 Natural Gas Furnace not functioning properly. We have replaced pressure switch, hot surface ignitor, flame sensor and control board. It will cycle 3 to 4 times and then not come back on. Is it possibly a bad coil on gas valve?:rolleyes:

Gas Valve Test Points [ 31 Answers ]

I read another post on here similar to mine. My furnace is on and everything, but cold air is coming out of the ducts. The post said to try tapping the gas valve (in case it is stuck). That didn't work. Also, I read that there is supposed to be 24 VDC on the valve prior to lighting off the...

Gas valve test [ 3 Answers ]

Is there a way to test a gas valve on a roof top ac? Seems to me that when I went to AC school ( about 30 years ago) there was a way to check the pressure at a valve using a manometer. Is this possible are what? Frank

Gas Valve pressure test [ 5 Answers ]

I just ordered a new gas valve for my fireplace. I damaged my old one by blowing compressed air into it to remove spiders that had found their way in through the gas orifice to the burner. Question: how do I test the water column pressure on the new valve, or do I assume it already comes pre-set...

View more questions Search