Ask Experts Questions for FREE Help !
Ask
    NicolePrice's Avatar
    NicolePrice Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 1, 2011, 07:12 PM
    Pilot won't light
    After not using the furnace over the summer I tried to light pilot and can't get it to light... what do I do?
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #2

    Oct 1, 2011, 07:29 PM
    No flame at all on the pilot when you try to light it? Check to make sure you have all gas shut offs on, if you have a flame and it will not stay lit, sounds like a bad thermocouple.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Propane Furnace won't start no pilot light red light flashes 3 times [ 6 Answers ]

My propane furnace G6RC has no visible flame and the red light either stays on or flashes 3 times in a row and then the furnace shuts off and tries to restart

Gas wall heater pilot light goes out when I turn the valve from 'pilot' to 'on'. [ 1 Answers ]

Why does my gas wall heater pilot light go out when I turn the valve from 'pilot' to 'on'? The pilot lights and stays lit until I try to turn the valve. It's got a brand new thermocouple.

I cannot find the button to push to light pilot light on older Maytag washer. [ 6 Answers ]

I am trying to light the pilot light on my older Maytag dryer. I cannot find any button to push while lighting the light area. All I see are screws, and electrical wire connections. The dryer does not heat and I assume that it is old enough to have a pilot that needs lighting. Thanks

Does putting gas hot water heater dial on PILOT put pilot light out? [ 5 Answers ]

My gas hot water heater dial has OFF to the left, PILOT in the middle and ON to the right. If we are going away and want to not have the water heated can we just turn the dial to PILOT and the flame will stay lit but just won't heat the water or does the flame go out completely and then PILOT would...

Pilot light stays on but pilot switch keeps resetting [ 5 Answers ]

I have a baso L62AA-5 pilot switch and it used to keep resetting. I would hold the switch down for a good minute and the gas lights, but after a half an hour or so it would go back to its reset position. The standing pilot light was always on and never a problem. After a few days of manually...

View more questions Search