Ask Experts Questions for FREE Help !
Ask
    richj123's Avatar
    richj123 Posts: 1, Reputation: 1
    New Member
     
    #1

    Sep 29, 2011, 01:26 PM
    Can deck rim joists be in 2 pieces?
    I have a 2nd story deck that I am repairing . One rim is 18' long .can I use two pieces to create this long rim joist
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
     
    #2

    Sep 29, 2011, 04:55 PM
    Is it only one or a double? How are the joists attached? I would only splice one if it was a double.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Deck joists [ 3 Answers ]

Deck joists that cantilever out past the deck posts, should never overhang the girder they rest on by more than: 35 times their width 2 feet 1 inch 6 feet

Deck top. We have a covered deck, planning on expanding deck, a 2x4 crossed cover [ 1 Answers ]

help!! We are planning on expanding our original deck with an open 2x4 crossed cover... do you have pictures or construction help?? Thanks

Notching rim joists to accommodate anchor bolts & washers? [ 1 Answers ]

When building floors on stem walls, do you always have to notch out the rim joist to accommodate the anchor bolt or mostly the 2"x2" washer? Can you give me some suggestions on ways that you get around this problem? Thanks.

Front rim joist from multiple pieces of wood? [ 4 Answers ]

I have designed my deck as shown below 12318 With a center beam taking most of the load, and posts supporting the front rim/header (I left out the joists for clarity). I tried to indicate that I have chosen to make the front rim/header joist from 12' stock, two 11' pieces and a 6' piece, with...

Can I "Sister" new wood onto my deck joists? [ 2 Answers ]

I have a deck that is cantelivered off the side of my house the Deck is 4'8" X 21'6". I ere should I place the bolts?noticed that approximately 5 of the 22 joists are rotted at the end and the rot is from about 2 - 8 '' in length. Would it be all right to "sister" on new 2 by 8's . How many bolts...


View more questions Search