Ask Experts Questions for FREE Help !
Ask
    hale970's Avatar
    hale970 Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Sep 24, 2011, 11:40 AM
    Armstrong ultra sx80 won't start after shuting off gas
    I shut off my gas to my Armstrong ultra sx80 furnace now it won't light the thermostat is working with a jumper wire the fan works but seams like no gas is coming true help
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #2

    Sep 24, 2011, 06:03 PM
    Do you know if the pressure switch is closing after the inducer motor is running.
    hale970's Avatar
    hale970 Posts: 3, Reputation: 1
    New Member
    		  
    #3

    Sep 24, 2011, 06:53 PM
    No I don't know anything about this at all I am a carpenter and lost
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Pilot lights up but the furnace won't burn on armstrong ultra sx80 [ 1 Answers ]

Armstrong Ultra Sx80 A/C burns the transformer [ 2 Answers ]

Tried to run AC for the first time this season (Furnace works fine). After looking around, the transformer was definitely burnt. Bought a new one, swapped it out (after carefully re-connecting the proper wires), and the AC worked. About a day later, transformer burned out again. Bought a new...

Armstrong Ultra SX80 not turning on by iteslf! Circuit Board? [ 1 Answers ]

This all started about a week ago. One night we woke up to a very cold house. The furnace hadn't kicked on at all during the night. It's an Armstrong ultra sx80. It has the automatic ignition. When I went to check on it, I took off the panels and vaccuumed it out and noticed that when I ran the...

Armstrong Ultra SX80 Heat Exchanger Failure [ 7 Answers ]

I recently experienced a series of small explosions while my furnace was operating. After extensive troubleshooting, I discovered the rollout switch was tripped, after I reset it, I watched the furnace startup properly, but as soon as the blower came on, it had extensive blowback tripping the...

Armstrong sx80 [ 5 Answers ]

I'm new to the sight, but am fairly handy around the house. I love doing my own repairs. My furnace would not light. The local tech that installed the furnace said he cleaned something, and the furnace has been lighting fine but the air coming out of the blower is much cooler. I had him back...

View more questions Search