Ask Experts Questions for FREE Help !
Ask
    Ron3D's Avatar
    Ron3D Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 7, 2011, 01:52 PM
    Troy-Bilt "Bronco" will not completely disengage blades?
    When I disegage the mower blades, I have noticed that they are still turning about 1/3 of the speed. I can not get them fully disengaged.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Aug 7, 2011, 04:58 PM

    Did you or anyone replace belts or make adjustments lately?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Troy bilt bronco keeps dying [ 3 Answers ]

My 2004 bronco has just started to die on me after cutting about 3/4 of my half acre yard. It runs fine and then as if it has bound up it sputters and then dies. I wait a minute and it restarts and will make about one pass before it does the same thing over again. Here's what I done so far: new...

Troy bilt bronco won't start [ 2 Answers ]

I have a Troy Bilt Bronco and when you turn the key nothing happens. The same thing happened last year while it was under warranty, so I called place where it was fixed and they told me it was a blown fuse. In an answer you wrote a couple years ago, you said there were two fuses. I only found...

I used cheap blades on my troy-bilt pony mower &now my oem blades slip help? [ 2 Answers ]

Ndering which parts to replace and where to find them?

Troy Bilt 42 in Super Bronco Cutting Blades [ 2 Answers ]

I can not get the nuts of to change the cutting blades on mower The original blades are on it. The nut will not turn ether direction.

Troy Bilt Bronco Weedeater [ 1 Answers ]

Problems with starting our Troy Bilt Weedeater. Less than a year old. Hard to start And once it starts, automatically shuts off as if struggling for gas. We have cleaned and changed spark plug and Changed oil mixture... Any Suggestions? Thanks, Kim & Ed

View more questions Search