 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Whirlpool motor make noise
Hi everybody I'm new here I have a whirlpool washer about 4yrds old the type of my machine is ultimate care series2 and it start to noise when the washer is spined or wash, when the washer is turning it make squeaky sound like the motor is dry or it scratch on to something, the sound is low when wash but when it rinse the sound it louder, please somebody help me out.
|
||||
|
||||
|
So the washer fills up correct? Now when its done filling up, it its starts to agitate (basically starts washing) the agitator starts turning. Now when that's happening, does it make that noise? When it goes in the spin cycle, does it make noise as well? Its sound to me like you transmisson is bad. Of the information you gave me, that's all I can think of at this time because it was very little information. But it sounds to me like a bad transmission...
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I purchased 2 Hampton Bay Indoor/Outdoor fans w/ light kit and had them installed with a standard switch in February 2006. One of them is making a loud noise and only gets louder w/ each setting. I've checked to make sure all the screws and connections are tight, but it is still making an...
?? Our Hampton Bay ceiling fan/light combo (mdl AC-552 "MM""YL") makes noice only when the fan is on (loud humming - motor probably.) The noise diminishes greatly when the light is then turned on. The unit is on a wall rheostat power switch to dim the light and control the speed in addition to the...
Planning on removing and installing a new motor on our Whirlpool dryer tomorrow. I've been told that the job should be done from the front of the dryer. Can someone please advise me in the breaking down the front panels ( hopefully not literally )? Maybe somewhere that I can get an online manual...
I have a Whirlpool washer GSX9885JQ0 that burnt the motor and cap too. Is this a common problem. Is there a way to check the control board to see if that was the problem or is it one of those things that I need to replace the motor and if that burns up then next time I should replace the board...
I have installed 4 ceiling fans (2 Hampton Bay and 2 Hunter) and experienced the same thing. A humming sound from the motors on all of them. I used 12G wiring and spliced into 12G existing wiring in the attic. The mfrs don't understand why - one has asked if I have enough power going to them. ...
View more questions Search
|
