Ask Experts Questions for FREE Help !
Ask
    rsshields's Avatar
    rsshields Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jul 25, 2011, 09:33 AM
    How to take plastic top off trane xl1800 condenser unit.
    How to take plastic top off trane xl1800 condenser unit, so i can wash it.
    rsshields's Avatar
    rsshields Posts: 2, Reputation: 1
    New Member
    		  
    #2

    Aug 2, 2011, 09:31 AM
    I found that you have a small rectangle piece on the corners, pop them off and there is a bolt behind them. Unscrew all 4 corners and the top will lift off in one section.
    jukebob's Avatar
    jukebob Posts: 1, Reputation: 1
    New Member
    		  
    #3

    Jun 15, 2012, 10:50 AM
    Yes, you are right. The small 1" X 1 1/2" pieces do come off and expose the screws at each corner. Thanks for the info.
    BTW: Turn off power first.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Trane A/C condenser fan [ 4 Answers ]

I am working on a Trane 4 ton condenser. I need to know if the fan should be turning clockwise or counterclockwise. The rotation arrrow on the label shows clockwise, but when turning clockwise the fan is not blowing out the top. Instead it is pulling air in. Can I change the rotation of the fan?...

Replacing trane xe1000 condenser with a payne unit [ 7 Answers ]

Hi, I have a trane system the airhandler section replaced in 2007 and the trane xe1000 condenser is 9 yrs old, and seems the compressor is bad and believe it is a pump type. A contractor said he could replace the consender with a payne unit (regular type I think) and bypass the pump type and...

Clean Trane XL1800 [ 1 Answers ]

I've read some comments about how to access the Trane XL1800 condensing unit to clean the fins. None has clearly stated how to remove the top in order to remove the side panels. The side panels have a screw at the top which is shielded by the plastic top grilles. I don't see how to remove the...

Trane XL1800 3ton condensing unit [ 9 Answers ]

I've mated a 1991 Rheem Ahu with a 2001 Trane XL1800 Condensing Unit. He condensing unit is dual stage compressors and I have the high side wired to call. I know need to upgrade the ahu and the honeywell chronotherm III t-stat but budget is not allowing it yet. I had a new coil installed with a...

Trane A/C condenser motor not working [ 1 Answers ]

Is there a relay that triggers the Condenser motor? Also, I checked the voltage at the AC controller and it is at 26 VAC, is this a problem if it is intended to be 24?

View more questions Search