Ask Experts Questions for FREE Help !
Ask
    Prairie Village's Avatar
    Prairie Village Posts: 2, Reputation: 1
    New Member
     
    #1

    Aug 1, 2011, 07:21 AM
    Delta 3 handle shower faucet still leaking after replacing spring, cups.
    Could use your advice. Have a 15 yr old Delta 3 handle shower faucet. Over the years have been successful replacing the cup and springs. This time replaced the cup/spring, leaking worse than with old cup. So I bought a new stem,cup and spring, same results.

    Water dripping out is cold not warm or hot. Inspected inside (cold side)valving cup area is clean, little lime below outside the cup area. Not seeing or feeling any burrs. Handle turns nicely, no hang up. Guess it could be the hot side but that's leaked before and
    the drips are warm.

    I'm no plumber ;^)
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #2

    Aug 1, 2011, 01:08 PM

    Before you replaced the cups did you turn the water back on to flush any trash out of the open valve body? Sounds like you may have some dirt or trash in there. Good luck, Tom
    Prairie Village's Avatar
    Prairie Village Posts: 2, Reputation: 1
    New Member
     
    #3

    Aug 1, 2011, 04:17 PM
    Appreciate the reply. I flushed both hot and cold sides out. Had assumed the hot was fine, but no. Even had to
    Scrape (carefully) inside the hot side to get back to brass. Guessing lime deposits. Old stems looked good, new
    Cup/springs and buttoned back up. No drip. Thank you for the pointer!

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Replacing Leaking Mixet Shower Faucet Handle [ 17 Answers ]

I am trying to replace a leaking Mixet shower faucet. I've somewhat successfully removed the knob by breaking it off. Now I cannot remove the mixing handle/lever. The new one I purchased has a set screw. The original one does not yet it will not budge off the stem so I can get at the hex nut to...

Need to replace 'O' rings and Gaskets in Delta Faucet [ 1 Answers ]

My Delta faucet which is probably 30 years old constantly drips. I have replaced the shower head so know it is the faucet. It is a single handle push up for on and twist to the right or left for temperature control. How do I replace the o rings and gaskets? Thank you

Can't get brass bonnet off delta single handle shower faucet [ 3 Answers ]

My Delta Monitor single handle shower faucet leaks at the shower head. Delta sent me a free replacement cartridge to fix it. I can not get the brass bonnet to unscrew and I'm worried about breaking something. Any advice?

Leaking single handle Delta faucet in a bath tub [ 2 Answers ]

I have a steady-dripping single handle Delta faucet in an upstairs bathtub. It has a pretty good leak. How do I get to the leak to fix it and what do I need to replace?

Delta shower faucet leaks, how do I install seat and spring [ 2 Answers ]

My delta shower faucet is leaking, how do I install the seat and spring correctly ?


View more questions Search