 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
I have a hunter fan with 5 wires coming out of the two layer pull switch
Two of the wires say they are a neutral splicer and one comes from the fan to the switch and is blue and the other goes from the fan switch to a capasitor. I bought a new switch 5 wire pull switch but it does not have the same set up.
|
||||
Check out some similar questions!
Hello: I have removed the well tec E116997 switch as the chain broke off in the housing. I have Replaced the chain but can't get the right combination of positioning to get the pull sequence. I can buy a 3 pull light switch but don't know if that would be safe.There is a Capacitor in the circuit...
Our ceiling fan switch clicks but the fan does not go on. When I opened the housing, I saw that there was 6 wires, 2 of which were white. One of the white wire was not connected, it could have caused the fan to stop working (?). I do not know where this white wire should be connected to as all...
My wife and her mood pulled the fan speed cable and yanked it out of the fan. How can I remove the cover or get to the part so I can put the chain back in to turn on the fan. This is a hunmter 3 speed fan with 4 lights attached under the fan. I could not find the model number.
I have a Hunter 5 blade 52" fan I bought & installed in 1990. I don't have papers on it, nor do I even know where to look for a model number. Over the yrs the fan has worked w/o a problem. Last week I pulled the chain to adjust the speed and it broke and came off (from inside the fan)... I took...
Have a fan pull switch to replace and need info on installing the electrical wires to l,1,2,3, etc,, which colors go where? Thanks for all the help
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
