 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Trying to switch from a White-Rodgers heat pump thermostat to a Honeywell RTH3100C. T
Trying to switch from a White-Rodgers heat pump thermostat to a Honeywell RTH3100C. The wires on the old thermostat were connected as follows.
White was connected to W2 Red connected to R Yellow connected to Y Green was connected to O Blue was connected to C The new thermostat has the following E Aux Y G O L R B C Can anyone help me with the way this should be connected to get it to work |
||||
Check out some similar questions!
Trying to replace a Bryant heat pump thermostat with 8 wires connected with a Honeywell RTH3100C. Instruction guide says if W1, W2, and Y were connected, contact a HVAC tech. Honeywell customer service was no help. Any ideas?
Trying to get the new Honeywell Digital thermostat RTH 110B to work both in heating and cooling modes. 5 wire installation from old White rdogers thermostat. Wire colors are G Y W R Br. Have to switch the R wire with the Br wire to get fan oeprating or A/C. Then have to switch them back...
I have on old White-Rodgers 4 wire single transformer system I believe. Model 1F76W357. I am installing a Honeywell RTH3100C non programmable thermostat. Wires on the White-Rodgers are: RC RH (Jumpered inside the thermostat) W Y G
I am looking at buying a new thermostat and I am trying to decide which to buy the Honeywell 8000 or the White-Rodgers 90 series (1F95-1277). I am also trying to determine what the difference is between the two White-Rodger 90 series models (1F95-1277 and the 1F97-1277). I know what the...
I have a Rheem heat pump with auxiliary and emergency heat. My current thermostat is a Seco TA-2000 with the following wiring configuration: B W2 X R G and a piece of wire connected between E and W2. There's also an orange wire that's not connected to the thermostat. The Honeywell manual does not...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
