Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Briggs and stratton vanguard 16 hp twin engine with no spark
[ 10 Answers ]
I have a new Briggs and Stratton Vanguard 16hp twin installed in an ATV. Unfortunately on a shakedown run the exhaust pipe loosened and fell on the wireing harness from the ignition key and the engine immediately stopped as the pipe melted through the wire insulation, I assume shorting something...
Briggs & Stratton Vanguard Engine Won't Start
[ 5 Answers ]
I have an 1998 Ingersoll 4016 with a 16 HP Vanguard engine. When I try to start it, it sounds and feels like the starter is spinning but not engaging the flywheel. I have not had any problems starting until now. It has about 220 hours.
Briggs and Stratton Vanguard 16 HP Vertical engine
[ 1 Answers ]
Briggs and Stratton Vanguard 16 HP Vertical engine what is the push rod gap for intake and exust
Briggs and Stratton Vanguard 18 hp engine
[ 2 Answers ]
Can someone tell me how to drain the oil on a Vanguard Briggs and Stratton 18 hp engine? I have located the drain plug but there is some kind of plastic fitting over it with a flip-off nozzle on the end as if this is where the oil drains. It does not appear that the plastic fitting comes off. So,...
Briggs and Stratton Vanguard OHV Engine
[ 1 Answers ]
I have a new Briggs and Stratton 8000 watt generator powered by a Vanguard 15 hp overhead valve engine.Since it came from the factory it has a popping sound from the muffler as it runs. It seems as though there is a misfire. The spark plug has been changed and the spark is in spec. Service dealers... View more questions Search
|