Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Redox Titration, please help.
[ 5 Answers ]
Hello everyone. I'm trying to figure out how much iron is in the iron tablets by way of a redox titration. So far in my report I have: KMnO4 0.01mol dm^-3 and I used 25.4cm^3 of it to titrate the iron tablet 5g. I balanced the equation and the stoichiometric ratio is 5:1, so 5 Fe^2+ reacting with 1...
Titration
[ 1 Answers ]
Please help me with this part of problem/ Pb2+(aq) + EDTA2-(aq) -> PbEDTA(aq) A 10.00 mL sample of the water from the holding tank requires 35.47 mL of 8.193 x 10-4 M EDTA to reach the end point. (A) What will be the molar concentration of lead(II) ions if you added a 10% excess...
Titration
[ 2 Answers ]
A 10.00 mL sample of the water from the holding tank requires 35.47 mL of 8.193 x 10-4 M EDTA to reach the end point. (A) Based on this titration, what is the concentration of lead(II) ions in the holding tank? here, I try to start the problem by writing following equation: Pb2+(aq) + ...
Redox Titration
[ 1 Answers ]
How would I find the RMM of the unknown metal if the molarity of HCl = 0.1 M , NaOH = 0.1 The Metal was dissolved in 80 cm3 of HCL and titrated against 22. 74 cm3 of NaOH. The mass of the metal was 0.0686 g.
Redox titration using iron tablet solution and potassium permanganate
[ 0 Answers ]
I am doing reox titration and not sure how to do calculation of iron in tablets. Basically I find the concentration of potassium permanganate solution using mol/vol. I know the volume but don't know the moles. Is it suppose to be written in the bottle? If so I forgot to write it down. Once... View more questions Search
|