Ask Experts Questions for FREE Help !
Ask
    jradliff's Avatar
    jradliff Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 18, 2011, 10:10 AM
    Engine with bent pushrods
    I bought mine April 07 also with Briggs motor. This happened to me last year and the push rods in the one cylinder got bent. The dealer rebuilt the one side and one year later my engine blew again. Mine started hard like this a few times before it blew for good. Sounds like your on your way. I now have a mower that cost $4,000 and is worth nothing unless I buy a $900.00 block. I think this residential model is junk. I have had nothing but four years of problems.
    DG's Avatar
    DG Posts: 1,375, Reputation: 109
    Ultra Member
    		  
    #2

    Jun 19, 2011, 07:39 PM

    Look at smallenginewarehouse.com
    You can buy a complete engine for that.. Luck
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

What to do if crankshaft is bent [ 1 Answers ]

What to do if crankshaft is bent

Penis bent [ 3 Answers ]

My penis point downwards when irected, does not hurt really but I'm embaressed of what my girlfriend will say, not sure if its peyronies disease, please help

If ones spine has a bent [ 2 Answers ]

Thank you

Bent turbine [ 2 Answers ]

What if you clean the air filter regularly? Can it happen from when the rod was replaced? The oil started leaking from the turbo base right after the initial repair of the worn out rod that caused the oil to originally leak. Then there was a vibration noise for about six months that continually...

View more questions Search