Check out some similar questions!
12.5 HP Briggs engine runs to fast.
[ 8 Answers ]
My ridding mower engine starts fine but runs estremely fast and I can't slow it down. Governor seems to be working as arm moves on start up and stays there. Turned fuel, air mixture closed with no slow down from engine. Any ideas?? needsinfo44
Briggs and stratton runs too fast
[ 1 Answers ]
I have a 4.5 hp briggs and stratton push mower. I am fixing it up as it wasn't working when I got it. I was able to start it and now it's running way too fast. I don't know where the governor is. The mower is about 6 years old. It's a BOLEN from Lowe's. Any directions or pictures would be greatly...
Briggs and stratton engine 18.5 runs bad
[ 2 Answers ]
18.5 intek b/s engine. Sometimes hard to start, when running it smokes out exhaust. Also smoke coming out of fuel pump vent hole. Runs better at full throttle but w/more oil from fuel pump coming out. Oil level is not overfull, any solutions?
Briggs and Stratton engine runs lean
[ 2 Answers ]
Hello, My daughter has a small push mower with a Briggs and Stratton Series 300, 148 cc engine that runs lean after the initial startup. It seems to run okay for about the first 20 seconds after startup, but then it starts running rough and behaves as if it is running out of gas. It seems to...
Briggs & Stratton 10 HP OHV Generator Engine runs rough
[ 3 Answers ]
I have a portable generator with a Briggs & Stratton 10HP OHV engine. I store it for months at a time and then add just enough gas to run if for about an hour until it runs out of gas. After two years the engine now runs rough. I have to leave the run/choke switch almost on full choke to keep the... View more questions Search
Add your answer here.
|