 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
You would need to determine the total load on the circuit and size accordingly. The most you could hope to run on a standard outlet is 20 Amps which would give you 2400 Watts, about 2 hair dryers. A 10 AWG wire would give you 30 Amps, used with a 30 Amp outlet but is very difficult to bend and install and is a dedicated circuit usually used for a compressor or something like that. You may find it easier to install some subpanels and run to the outlets from the subpanel.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I need to install a lit exit sign in a 759 sq ft. office. The door that I am putting this unit above is located far from the other already installed exit sign and would require going through a block wall at an added expense to the customer. Will the code allow me to connect the sign to an...
What's the distance for gfci from water fixture?
What is the ampacity of a #3 aluminum conductor in free air
After 30 years of experience I was red tagged believe it or not here's my question to you experts At a meter loop I connected branch feeders to 100 amp disconnect I was red tagged for different size wire was that darn inspector correct I did not parallel wire could this inspector be talking about...
I will be working in a remote mountain location without available electricity. We explore for gold in case you are interested. We have an old mining shop available that has a 200 amp service (in good condition). We would like to power the shop with a 40 KW 240/120, 200 amp, single phase diesal...
View more questions Search
|
