Hose sizes

maliktalat Posts: 1, Reputation: 1

New Member

Jun 5, 2011, 01:00 AM

Hose sizes

Why flexible connecting hoses come in mm and inches e.g. 15mm to 1/2in I cannt find 15mm to 15mm hose with valve

joypulv Posts: 21,591, Reputation: 2941

current pert

Jun 5, 2011, 07:27 AM

What country are you in? Do you mean 1/2" Pex for water supply?

Add your answer here.

Check out some similar questions!

If a hose is connected to a hose bibb will we be able to get water from our neighbor? [ 4 Answers ]

Our main water line is broken, we have hooked up a garden hose from a water source to our outside hose bibb, but we have no water inside. We understood this was a temporary fix, are we doing something wrong? The hose bibb is not a frost-freeze, and we have water coming out of the garden hose when...

How do I stop leaking around the hose cuff where the hose screws in? [ 1 Answers ]

I just installed an above ground pool. I bought hoses from Home Depot because the ones that came with the pool were too short. I had to buy the hose by the foot so the ends have the coils and not the end pieces that the factory hoses have. I bought hose cuffs to screw onto the ends and then the...

Shower Hose Leaking, removed hose pipe drips [ 5 Answers ]

Previously it was leaking at the top where shower hose goes onto the threads of the pipe at top, I wrapped the threads with teflon tape so that now that part is dry, no leaking, but the hose continues to leak at the bottom (hand held piece). I totally unscrewed the shower hose from the pipe and see...

How to unscrew shower hose to cut the leaking part of hose [ 1 Answers ]

How to unscrew shower hose to cut the leaking part of hose: I found a crack or tear inside shower card near to end. I've successfully unscrew the shower head, but not able to unscrew the remaining, so that I can cut the damaged part out... it looks like new and shiney, but it's very tightout...

Drain pipe sizes and venting sizes [ 4 Answers ]

1.) What dia. Drain pipe is used for the shower/tub? 2" ? Is that ID or OD? 2.) What dia vent pipe is for the shower/tub? 2"? 3.) I'm going to put a vent in for the shower/tub in my basement. It starts at the slab then goes straight up about 7ft. And then does a 90 and then is running...