Ask Experts Questions for FREE Help !
Ask
    windroddy2's Avatar
    windroddy2 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 8, 2011, 07:50 AM
    Troy bilt bronco, turns over but does not start
    I was cutting lawn and it died. Fresh gas in tank , new plug, has compression but yet it won't start, what gives
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    May 8, 2011, 02:09 PM

    That's the tractor maker and we need to know about the engine. Brand, HP , model and serial # will help.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Troy bilt bronco keeps dying [ 3 Answers ]

My 2004 bronco has just started to die on me after cutting about 3/4 of my half acre yard. It runs fine and then as if it has bound up it sputters and then dies. I wait a minute and it restarts and will make about one pass before it does the same thing over again. Here's what I done so far: new...

Troy-bilt Super Bronco will not start [ 0 Answers ]

I have a model 13AT609G766 Super Bronco with a 21.0hpv twin it will not start, I had it running and when I pushed the lever to start the mower blades it died now it won't start. Can anyone help me, it will start if I spray starting fluid on the air filter but it dies after it burns off the starting...

Troy bilt bronco won't start [ 2 Answers ]

I have a Troy Bilt Bronco and when you turn the key nothing happens. The same thing happened last year while it was under warranty, so I called place where it was fixed and they told me it was a blown fuse. In an answer you wrote a couple years ago, you said there were two fuses. I only found...

Troy Bilt Super Bronco [ 1 Answers ]

Looking for a diagram of a Super Bronco deck. Had to replace a tension spring but don't think is in the correct place. The diagram in the manual isn't too clear on the springs placement. The belt is very loose and doesn't have the cutting power it used to.

Troy Bilt Bronco Weedeater [ 1 Answers ]

Problems with starting our Troy Bilt Weedeater. Less than a year old. Hard to start And once it starts, automatically shuts off as if struggling for gas. We have cleaned and changed spark plug and Changed oil mixture... Any Suggestions? Thanks, Kim & Ed

View more questions Search