Ask Experts Questions for FREE Help !
Ask
    gideon51's Avatar
    gideon51 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Apr 21, 2011, 01:35 PM
    Broken Bolens BL100 pull cord.
    How is the pull cord on the Bolens BL100 reound after replacement?
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Apr 21, 2011, 02:53 PM

    You wind it on the spool before it gets reinstalled, you also twist the spool a few rotations to put tension on the spool. This may help getting a manual if you don't have one. Bolens Trimmer BL 100/ BL 150
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bolens BL100 weedeater won't run for long. [ 4 Answers ]

Have a Bolens bl100 weed eater. Can't seem to keep the thing running. It is roughly a year old. Has run just fine up to this point. Put the carb choke on 1... pull the cord 5 times until the engine kicks over and wants to run. Then I move the carb choke on 2 and pull the cord. The engine runs for...

Snowblower won't start, made bad noise using electric, pull cord now hard to pull. [ 7 Answers ]

I tried to start my snowblower today and it wouldn't start. I decided to try the electric start, plugged it in, hit the start button and all it made was a spinny grinding noise. Unplugged it, and tried to start it manually with pull cord again. The cord would not pull without lots of effort and...

Bolens BL100 starter cord replacement [ 1 Answers ]

On Bolens BL100 string trimmer: How do you remove the "palnut" holding the cord pulley in place? Does it screw in or pull off? I fear breaking it. Thanks

Pull Cord won't pull on my Briggs and Stratton 650 Series push mower [ 5 Answers ]

Ok here goes... The pull cord is stuck. Its pulls out about 4 inches then the cord stops. Looking into the cord area ontop of mower, I notice a small white plastic piece getting caught in a notch built into the cord housing. Now... when I loosen the cord a little bit, I can slide a butter knife...

Pull cord won't pull on Murray 2.0 mower [ 7 Answers ]

I have a Murray/Briggs 6.0 engine mower and the pull cord is sticking. It will stop after pulling about 4 inches. Then if I jiggle the pull cord it will extend another 4 inches. I can see a plastic piece that seems to be stopping it at every four inches. What is causing this and what is the repair...

View more questions Search