Ask Experts Questions for FREE Help !
Ask
    davest's Avatar
    davest Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Apr 12, 2011, 01:09 PM
    Limit cycling
    Coleman furnace light blinks 4 times. Model dgat070bdd says limit cycling error. Upper lower switchs closed doest ignite does this for 5 min. then short cycles
    davest's Avatar
    davest Posts: 2, Reputation: 1
    New Member
    		  
    #2

    Apr 20, 2011, 06:43 AM
    Circuit board replaced OK
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Evcon Coleman furnace is giving me a limit cycling code. Any idea of how to fix? [ 0 Answers ]

I have an evcon coleman furnace and the only way to get it to turn on is to turn it down and than back up. A green light is blinking four times which means limit cycling. Any idea how to fix this? Thanks!

Limit cycling coleman evcon furnaces [ 1 Answers ]

On my Coleman Evcon Furnace, the light is blinking 4 times (limit cycling) what needs to be replaced to solve this problem?

A/c cycling too often [ 3 Answers ]

Just installd a honeywell thermostat (rth230b) it run until it reaches the set temp. then it shut off then it comes right back on within seconds. Please give some advice on what could be problem. Thanks

Furnace cycling [ 2 Answers ]

My newer energy efficient furnace cycles every 10 minutes about, I have a new one story home that is very well insulated.

Not cycling properly [ 2 Answers ]

My fan and gas shuts off after only a few minutes in the heating cycle and restarts again shortly, only to shut off again... and so on. I think it's the fan limit switch but don't know if I should replace it or try adjusting the limit. Any advice??

View more questions Search