Ask Experts Questions for FREE Help !
Ask
    stephenm's Avatar
    stephenm Posts: 11, Reputation: 1
    New Member
    		  
    #1

    Mar 23, 2011, 01:30 PM
    Do I need to cement my standpipe to the washer box?
    Do I need to cement my standpipe to the washer box?

    If so, any problems arising with using PVC cement on the connection?
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Mar 23, 2011, 02:02 PM

    Yes, use the right PVC cement and there should be no problems. Black & Decker Projects and Advice | Standpipe Drains
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #3

    Mar 23, 2011, 03:18 PM

    Agree with ballengerb1. Yes, clean and glue the connection just like you would the rest of the fittings.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Washer standpipe drain [ 11 Answers ]

I want to install a wall box with a standpipe drain for my washing machine. I'm trying to figure out how to plumb the drain line. Here are my questions: - Should I use 2" drain lines? - Do I need a trap (I'm assuming yes)? - Do I need a vent (I'm 32 inches or less from the stack)? - If I do...

Washer Standpipe Overflows [ 6 Answers ]

First a little background: We have had this washing machine since 2004. It is a high capacity Maytag Atlantis. We lived in San Antonio in a newish house and had no problems with overflow out of the wall. We recently (last 6months) moved into on base housing on a small base, and every load, every...

Overflowing standpipe? From washer [ 3 Answers ]

I am not sure if the metal pipe that comes from the floor is called a standpipe but water is overflowing from that pipe as the washer discharges, The rubber pipe from the machine seems to be OK but there seems to be a clog somewhere in that metal pipe.

Standpipe Design Question, Washer [ 11 Answers ]

Hi, This is my first post to these forums, I've been going nuts trying to find an answer to this question. But first, let me thank Speedball for posting a part of a plumbing code dealing with cutting and notching load bearing walls. 2 1/8 inch bit through the top plates of an exterior wall mid...

New Washer - Old Standpipe Backing Up [ 5 Answers ]

We bought a new washer 10/2006 and it immediately flooded our garage floor. The standpipe was leaking at the base anyway and I thought there was a clog so I decided to cut the old one off... augered 20 feet into the main line (which revealed nothing), repiped it and then poured virgin sulfuric...

View more questions Search