Ask Experts Questions for FREE Help !
Ask
    VicTab's Avatar
    VicTab Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 20, 2011, 06:09 PM
    Intermatic timer T104R installation?
    Whould somebody tell me how to install the T194R timer to a water bomb 1.5 hP 15amp and another pump 1hp both used for water fall.

    Hanks, Vic
    tkrussell's Avatar
    tkrussell Posts: 9,659, Reputation: 725
    Uber Member
    		  
    #2

    Mar 22, 2011, 05:31 AM
    Since the title of the question states T104R, is the T194R in the body of your question a typo?

    The instruction manual for the T104 has a wiring diagram.

    http://www.intermatic.com/~/media/fi...20english.ashx

    This unit has a 240 volt timer motor and is designed to switch a 240 volt load.

    Are the two motors you have 240 volts?

    Assuming both are on the same circuit, the 1 HP motor at 240 volts is 8 amps, and the 1.5 HP is at 10 amps, totalling 18 amps.

    This circuit needs to be a minimum of 30 amp circuit with a 2 pole 30 amp breaker and all #10 copper wire.

    If these pumps are for a fountain, or something that peple will enter, the breaker needs to be a Ground Fault device.

    What are these pumps for?

    What else do you need help with?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Wiring for a T104R Timer [ 1 Answers ]

I am trying to install a T104R timer to my outside pool and 3 outlets There is 3 conduts going into the box one is from the breaker box (pool ) other two have two wires each both outlets How would the timer be hooked up . Thanks Tom

Intermatic Clock Timer Installation [ 2 Answers ]

My clock on an Intermatic T101P3 timer went belly up and I got a new 110V model. However the problem with the new unit is that the output gear location is slightly different relative to the two mounting holes. This means that I can bolt the clock onto the body, the gear doesn't mesh and driver the...

Wiring intermatic T104R timer [ 6 Answers ]

Hi everybody! I work as a handyman. While trying to install an intermatic t104r timer, I found that th E clock does not work. I believe I followed the diagram. Manually It works, but I do not hear the clock ticking. Is it supposed to? ...

Intermatic t103 timer hook up [ 1 Answers ]

Hi I just installed a Intermatic T103 timer to my water heater. It doesn't seem to be working. I hooked it up two different ways and still the timer stays still. I first hooked it up as the spec. lines 1 and 3 were my line and lines 2 and 4 were my load nothing. Than I tried because it is a 220v...

Intermatic wall timer/switch [ 4 Answers ]

I would like to install one of those cool in wall programmable timer/switch but have a question. The switch I would like to replace controls 2-500watt halogen lights, 2-150watt incandescent flood bulbs, 60watt outside door light, and finally 2-150watt halogen lights which totals up to 1660watts. ...

View more questions Search