Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Installing Floor Registers to Draw Basement Heat
[ 7 Answers ]
I have a 2-story colonial in CT. The heating system for the house is oil-fired (forced hot air). A couple of years ago, I finished the basement and made it a den. Since there was no heat in the basement, I installed a propane heater made for rooms - the one I installed (a Rinnai) is actually rated...
Most efficient heat system
[ 3 Answers ]
added 24x28 addition with 20x28 basement for my mother to live in. she is very cold natured and I'm looking for the best/most efficient/cheapest type of heat for her. There will be a woodstove in the basement as backup/assist heat. She may need oxygen in the future, so can't have anything with...
Cold setting produces heat while heat setting does the same. Need cold air.
[ 6 Answers ]
Just installed a honeywell rth221 and when placed in the heat position, it heats and when in the cool position, it heats. Why can I not get cold air? Old thermostat was a lenox with R, Y1, G, O, W1, C, New thermostat has only Y G on one side and Rh, Rc, and W on other with removable jumper...
Attic Heat Pump Creates Draft Through Registers
[ 1 Answers ]
Hi, I bought a house with a standard natural gas furnace and a heat pump in the attic. The heat pump works great when I test it, but if I leave the switch on the thermostat set to EM HT (i.e. heat pump), once the heat kicks off it is replaced by a steady flow of cool air through the... View more questions Search
|