7 Flashes - Lockout caused by no Ignition

OttoA Posts: 2, Reputation: 1

New Member

Mar 16, 2011, 09:27 AM

7 Flashes - Lockout caused by no Ignition

ballengerb1 Posts: 27,378, Reputation: 2280

Home Repair & Remodeling Expert

Mar 16, 2011, 10:00 AM

So what brand/model furnace is goving this code? Most lock out are resettable if you can follw the wiring to the switch.

Add your answer here.

Check out some similar questions!

York furnace ignition lockout on retries [ 0 Answers ]

My york furnace is flashing the 7 code, ignition lockout due to retries, what can be the cause of this?

My furnace fault code light flashes three times the pause and flashes three times aga [ 3 Answers ]

My furnace fault code light flashes three times the pause and flashes three times again and repeats. What is wrong?

Bryant 355MAV error 34 & 14 Ignition Lockout [ 13 Answers ]

Hi everyone, I own a Bryant 355MAV furnace which has been installed since Autumn 2001 and run without trouble since then (except a minor airflow issue last winter which was helpfully solved here in this forum). I've been running the heater for most mornings since early October without issue....

Trane Furnace error code = 2 flashes, what does system lockout mean? [ 1 Answers ]

I have a Trane forced air furnace which recently has had periods when it blows unheated air. When I looked at the furnace during these periods it shows 2 flashes, which according to the instruction manual is an error code which means: System lockout, retries or recycles exceeded. I don't...

Carrier Ignition Lockout Code & Ignitor Problem [ 3 Answers ]

The code I'm getting is 14 for ignition lockout, will reset in 3 hrs. The furnace tries to ignite 3 or 4 times and then the code trips and shuts the furnace down. I usually just flip the manual switch to get it going again but if I'm not home to pay attention or if we're asleep the house will...