Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Bathroom wiring diagram
[ 7 Answers ]
I have this set up A bathroom split into two areas tub and shower in one, and toilet and lav in the other. I have 4 recessed lights on a switch, 2 in each area. A fan switch is also in this box. I have another box at the lav with a receptical and a switch for a light over the lav. I...
Sewage Ejector Pump in Downstairs Bathroom
[ 8 Answers ]
Greetings, I installed a sewage ejector pump to code and not exceeding the 12 foot head on this model. However when it ejects water it almost seems that 1/2 of what it shoots up comes back down into the pit. To you professionals, how can I remedy this. Ideally, almost all fluids pumped should...
Venting a basement bathroom with a sewage pump
[ 1 Answers ]
Good day, All I am trying to figure out the venting for my basement bathroom. I am running a 4" waste drain from the toilet to my sewage holding tank, (one of those inground ones with a pump)which takes a 3" vent. I will also tie in a shower (2") and a sink (1.5 or 2")to the 4" main drain. Do...
Bathroom wiring diagram
[ 8 Answers ]
I am wiring a new basement bathroom. I have created a diagram showing how I plan to wire it. Just curious if anyone sees any problems with the way I'm doing this? Thanks and hope the attachment shows up correctly!
Typical bathroom group diagram
[ 1 Answers ]
Tom, I've been scouring the Internet for diagrams of what you've described as a "typical bathroom group" -- and the only one I've found so far is this: http://i228.photobucket.com/albums/ee112/jameslrice/14040_72_2.jpg I notice in this diagram, everything appears to be tied in to the main... View more questions Search
|