Ask Experts Questions for FREE Help !
Ask
    jeffb27's Avatar
    jeffb27 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Mar 7, 2011, 09:43 PM
    Dual thermostats with one furnace no heat on one side of the house
    I have a client with a single furnace dual thermostats single level house. Both thermostats seem to be working but suddenly only half the house is getting warm air
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Mar 8, 2011, 07:17 PM
    I'm assuming there is a zone control panel and 2 zone valves. Check to see if the zone control panel is blinking an error code and also check that the zone valve is operating. Simplest way to check the zone valves is to reverse the wires from the zones on the control panel and set the t'stats. If the unheating zone now works, you probably have a bad zone valve.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Dual thermostats with one furnace [ 0 Answers ]

I have one furnace with 2 thermostats, the thermostats seem too be working but suddenly only one half of the home is getting air

I want have two thermostats in the house one for a/c and one for heat. [ 1 Answers ]

I have a programmable themostat that operates both heat and a/c. I would like to add a thermostat closer to the kitchen to keep it warmer And make the programmable thermostat now in the hallway for a/c only.. How can I wire these two thermostats and make that work? Thank you for your...

How do I get furnace heating fan to stay on to heat the house [ 3 Answers ]

When I turn on the heater the gas comes on in the furnace the fan in the furnace powers up and than shuts off then the gas in the furnace shuts off I reached in the furnace and turned the fan by hand and sometimes it will go through the cycle and the heat comes on and the fan will run for 30 min....

Replacing dual-zone thermostats [ 6 Answers ]

The house had a two-zone heat/cool system, with two non-programmable thermostats (round ones). I replaced the MASTER thermostat with the Honeywell RTH6400 (programmable). It seems to work fine. However, the old thermostat had two wires too many to be accommodated in the new one, so I left them...

Dual switchable thermostats for heat pump control at night. [ 6 Answers ]

I would like to have my heat pump controlled by the centrally located main thermostat during the day, but switch to a different thermostat located in my bedroom during the night. Is this possible and how would I go about wiring it? I was hoping it may be a readily available kit?

View more questions Search