Ask Experts Questions for FREE Help !
Ask
    tisss's Avatar
    tisss Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 3, 2011, 05:45 PM
    Will my dual heat work without gas?
    My gas got shut off and won't be back on until next week. Is there a way to use the heat without gas since it's dual heat?
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #2

    Mar 3, 2011, 07:29 PM
    It depends on the control that conrols the gas side. With some of the newer systems, switch over and lock out of the furnace and heat pump is done from the thermostat. If you don't tell the system not to use the furnace, the system will lock out and you will not have gas or heat pump --heat.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Dual zone gas heat w/ forced air up is blowing cold air on second floor. [ 1 Answers ]

We have a gas furnace with two thermostats and forced air on the second floor. The heat works fin everywhere but the second floor. The temperature is dropping and the registers have cold air blowing out of them. Any suggestions on what the problem could be?

Heat Pump blows 5amp fuse when switching between defrost & back to heat. Them Heat work [ 3 Answers ]

I have a Carrier Heat Pump System. It’s about 5 years old and has functioned OK until this Christmas Eve. One problem is the condensing unit is not kicking back on after it goes into defrost mode. I found a 5AMP fuse blown in the attic unit and once replaced it functioned. At least for a day or two...

Gas furnace - heat doesn't work unless fan is in the on position [ 4 Answers ]

I have a gas furnace that will only work when the fan is on "ON'. I changed the thermostat, same problem. Changed the circuit board, same problem. Changed the ignition modulator, same problem. Changed the fan motor, same problem. Any ideas?

Dryer Maytag Gas Heat Does Not Work [ 1 Answers ]

It's a Maytag gas dryer #LDG7304AAE. I replaced the belt. When I put is back on, the heat does not work. Gas line is open, vent is open, blower works. Timer works And I did run it for 10 minutes in the hope it might start up later. No success.:confused:

View more questions Search