Ask Experts Questions for FREE Help !
Ask
    know222's Avatar
    know222 Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Mar 3, 2011, 03:58 PM
    What wires do I switch on my 115/230 to change it back to a 230 service
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #2

    Mar 3, 2011, 04:13 PM

    Did you forget to say motor, If so it may be on the Nameplate or inside the nameplate cover, If Not, you will have to tell us more. Manufacturer, model number etc. More the better
    know222's Avatar
    know222 Posts: 3, Reputation: 1
    New Member
    		  
    #3

    Mar 3, 2011, 04:24 PM
    Rewire motor from115 to 230
    The motor is a 2hp 115/230 GE model 5kcr48sr36u CAT#3k787 and the nameplate is missing.It was set up for 230 before and I changed it over.Now I'm 64 and have since forgot.Thanks for your help Jerry
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

230 volt DC lathe motor [ 16 Answers ]

I recently purchased a new german made lathe with a 1 and 1/2 h.p. single phase DC motor rated at 1400 watts at 2800 rpm, the plate on the motor says 60 hertz. 6 amp nominal consumption 230 volts. I also purchased a 110volt to 220 volt step-up transformer rated at 2300 watts. The lathe has a...

230 volt Motor wiring [ 11 Answers ]

I have a 6 hp 230 volt air compressor motor that I have wired on a twin 20 amp breaker with a 10/2 wire. I cannot get the motor to start, I have took it off and had it checked and it works fine, just not when I wire it up in my garage. I do have power at my 10/2 wire, and cannot understand why it...

Connections for 230 v motor [ 1 Answers ]

I have a BN40 220 volt single speed motor for a second pump. I am trying to wire a cord (J&J mini)that has four wires: green (ground) white (neutral) black and red (hot). My question is: 1) which two wires (excluding the ground) do I connect to the two terminals in the motor? 2) If one of...

View more questions Search