 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Generator carburetor
I have a generac Briggs & Stratton wheelhouse 5500 generater. The pull start broke to fix it I had to take off the carburetor bowl. I need to know how this float assembly goes back together. This carb is different than the others I've seen. The float is a plastic insert with a spring in the bottom center of the bowl, the bowl is held on by two bolts instead of one bolt in the bottom center & there's a brass jet like thing I think to reduce or regulate the gas.I can send u a picture if needed. Generater model # 01646
|
||||
Check out some similar questions!
Generator wiring: I have a new honda generator. I ran 3 wires from the garage to the transfer switch in the house. When I start up and throw in the breaker on the generator, its GFCI trips immediately. It is a long run (125ft) run to the house and I used heavy wires. But I only ran 3 (blk,...
For connecting 7 MW generator to generator transformer, which is better cable or NSPB ?
I require for a Power Plus 5000 Generator 1 generator under following specifications: 5000 Watts, 120V, 1 Phase, 60 Hz at 3600 RPM, 3720 RPM at no-load. Thank you, Publio
I have a MTD 17.5 HP riding mower. When I start the engine it sound like there is a large amount of gas going to the engine thena small amount. I removed the air filter and gas filled the area where the air filter set. I figure my problem is in the carb. Any suggestions appreciated. Thanks
I have a **!#$$* Poulan Prolink PPB 250E string trimmer. Just put a new carb on it, thinking that was my problem. It will now at least crank with the choke on and run pretty well, finally winding up to a fairly high rpm. However, no matter how warmed up it gets, when you turn the "choke" from start...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
